Remington REM10PT Uživatelský manuál stáhnout pdf (Strana 13)

110373-01B

For more information, visit www.desatech.com

For more information, visit www.desatech.com

13

13

TROUBLESHOOTING

WARNING: Turn off heater

and let cool before servicing.

Only a qualified service per-

son should service and repair

heater.

CAUTION: Never use a wire,

needle, or similar object to clean

ODS/pilot. This can damage ODS/

pilot unit.

POSSIBLE CAUSE

1. Ignitor electrode positioned wrong

2. Ignitor electrode broken

3. Ignitor electrode not connected to igni-

tor cable

4. Ignitor cable pinched or wet

5. Piezo ignitor nut is loose

6. Broken ignitor cable

7. Bad piezo ignitor

1. Gas supply turned off or equipment

shutoff valve closed

2. Control knob not in PILOT position

3. Control knob not pressed in while in

PILOT position

4. Air in gas lines when installed

5. ODS/pilot is clogged

6. Gas regulator setting is not correct

1. Control knob not fully pressed in

2. Control knob not pressed in long enough

3. Safety interlock system has been trig-

gered

4. Equipment shutoff valve not fully open

5. Thermocouple connection loose at con-

trol valve

6. Pilot flame not touching thermocouple,

which allows thermocouple to cool,

causing pilot flame to go out. This prob-

lem could be caused by one or both of

the following:

A) Low gas pressure

B) Dirty or partially clogged ODS/pilot

7. Thermocouple damaged

8. Control valve damaged

REMEDY

1. Replace pilot assembly

2. Replace pilot assembly

3. Reconnect ignitor cable

4. Free ignitor cable if pinched by any

metal or tubing. Keep ignitor cable dry

5. Tighten nut holding piezo ignitor to

heater cabinet. Nut is located inside

heater cabinet at top

6. Replace ignitor cable

7. Replace piezo ignitor

1. Turn on gas supply or open equipment

shutoff valve

2. Turn control knob to PILOT position

3. Press in control knob while in PILOT

position

4. Continue holding down control knob.

Repeat igniting operation until air is re-

moved

5. Clean ODS/pilot (see Cleaning and

Maintenance, page 12) or replace ODS/

pilot assembly

6. Replace gas regulator

1. Press in control knob fully

2. After ODS/pilot lights, keep control

knob pressed in 30 seconds

3. Wait one minute for safety interlock sys-

tem to reset. Repeat ignition operation.

4. Fully open equipment shutoff valve

5.

Hand tighten until snug, then tighten 1/4

turn more

6.

A) Contact local propane/LP gas company

B) Clean ODS/pilot (see Cleaning and

Maintenance, page 12) or replace ODS/

pilot assembly

7. Replace pilot assembly

8. Replace control valve

OBSERVED PROBLEM

When ignitor button is pressed, there is no

spark at ODS/pilot

When ignitor button is pressed, there is

spark at ODS/pilot but no ignition

ODS/pilot lights but flame goes out when

control knob is released

Note:

All troubleshooting items are listed in

order of operation.

TROUBLESHOOTING

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Komentáře k této Příručce

Žádné komentáře